Industry-focused market entry reports

List of catalogs in this article:

• 1,Industry-focused market entry reports How is the effect of diesel engine intake heater
• 2 、How about the heating exhaust gas modified heating engine in winter
< Li style='margin-bottom: 3px;list-style: none'>6, The correct method of winter car heating machine

How is the effect of diesel engine intake heater

This brand of heater is easy to use. Yusheng diesel heater adopts advanced carbon semiconductor plastic heating new technology. The oil pipe of the product can automatically and intelligently adjust the heating power according to the change of external environmental temperature, ensuring sufficient oil supply at any temperature.

Diesel heater is good. Diesel heaters have significant advantages of high thermal efficiency, easy to use, high comfort, energy-saving and no noise. There is no need to start the engine. The advanced remote control and timing system can easily warm up your car in advance at any time to fully protect the engine.Its scope of application is getting wider and wider.

The advantage is to appropriately increase the number of heating tubes, improve the installed power of the air heater, and shorten the driving and heating time of the production line. The disadvantage is that if the speed is too high, the pressure loss will increase sharply, which will not be conducive to the improvement of heating efficiency.

The oil line heater of diesel vehicles can definitely be responsible and said to be useful! The first generation of diesel oil heater adopts the heating method of threading the heating wire in the tube. This heating method is unsafe to directly heat the fuel oil, and has the disadvantage that the power cannot be automatically adjusted, which is easy to cause serious problems such as burning the oil pipe and even fire.

Heating at the air intake is mainly to help the engine ignite under very low environmental problems, reduce lubrication resistance and increase the temperature in the combustion chamber, improve the fuel atomization effect, and have a good auxiliary performance for the start-up of the whole engine.

How to use the car heater

1. Before using the heater, you need to open the pipe valve to ensure that the pipe The liquid inside can be circulated, and coolant should be added at the same time, otherwise the dry grinding of the pump will cause high temperature and affect the damage of the water seal parts. It is strictly forbidden to turn off the heater with the help of the main power switch of the car to avoid overheating and damage to the host.

2. Turn on the car heater. The correct thing to do is to start the engine preheating first. When the engine temperature pointer reaches the middle position, turn on the heater. At the same time, set the air gas cycle to the external cycle, so that the cold air gas in the car can be discharged out of the car. Wait for 2 to 3 minutes before turning on the air combustion. Gas.

3. [Pacific Automobile Network] The usage method of the parking heater is: press the heater water pump switch, and the water pump works. This switch can be used to use the residual heat of the engine for in-car heating and windshield defrosting; press the heater switch, and the heater will start working and automatically ignite. When shutting down, turn off the heater switch first, and then turn off the water pump switch.

Urgent!!! SeekThe preheating principle of the automobile engine preheater

1. When the timer 3 is running, the preheating relay is on within the time determined according to the temperature of the coolant, and then the electric heating plug is heated. When the ignition switch is transferred from the "ST" position to the "on" position, it plays an auxiliary role in the start-up of the engine. The system mainly controls the preheating time in the following two forms: fixed delay type.

2. Then cycle into the engine to heat the engine to reach the normal ignition temperature. To put it bluntly, the car preheating device heats the engine, which solves the problem that the engine temperature is too low to ignite.

3. When the engine starts, after the preheater switch is turned on, the temperature of the electric heating wire rises and the valve body is heated. When heated, the valve body is stretched and drives the valve core down, and its conical end leaves the oil inlet hole.The fuel oil flowing into the valve body cavity is vaporized by heat, ejected from the valve body cavity, ignited by the hot wire to produce flames, and is sprayed into the intake pipe to preheat the intake air.

Working principle of wood heating parking heater

1. The working principle of wood heating parking heater is as follows: The working principle of car firewood heating is to use the battery and fuel tank of the car to instantly supply power and supply a small amount of oil, and by burning gasoline The heat generated is used to heat the engine circulating water to heat the engine and heat up the cab at the same time. Car wood heater is a car heater.

2. When the engine cooling temperature is below 80℃, the heater works; when the coolant temperature is above 80℃, the thermosulator works, automatically cuts off the power supply of the fuel pump, and the engine coolant provides the heat source.The diagram of the gas heating system is as follows: the fuel and air are mixed and burned in the combustion chamber, and the engine coolant is heated.

3. A small amount of fuel is extracted from the fuel tank to the combustion chamber of the parking heater, and then ignited by the igniter to obtain an open flame; the combustion chamber is connected to the coolant pipeline of the water tank, and the heated coolant circulates in the car; after flowing through the warm air radiator, the carriage is heated, and the engine is also preheated at the same time.

4. The working principle of automobile firewood heating: The working principle of automobile diesel heating is to use the vehicle's battery and fuel tank to instantly supply power and a small amount of oil to heat the circulating water of the engine by burning gasoline, so that the engine is hot started and the cab is warmed up at the same time.

How about the heating exhaust gas modified heating engine in winter

can.Car firewood heating is a car heater. It obtains heat through diesel combustion for heating. During the work, harmful gases will be generated, that is, the exhaust gas after diesel combustion. This exhaust gas has a special pipeline that can be discharged out of the car.

Yes. After querying the relevant information of the wood heating exhaust pipe of the car portal, it is learned that the wood heating exhaust pipe of the car portal can heat the engine of the car. Heating is a kind of parking heater, which uses diesel as fuel and burns to produce heat energy. It can be used independently when the truck is parked and turned off.

If the exhaust gas leaks and flows back into the car, the people in the car are in danger of poisoning. The firewood heater needs oxygen support in the process of combustion, so it will also consume the oxygen in the cab. These are all potential dangers of firewood.

WinterThe correct method of car heating engine

The correct method of car heating should be on the road 30 seconds to a minute after the car starts, but at this time, do not drive at a high speed, it should be kept at a low speed (about 3-5 minutes), generally kept below 2000 rpm (the rehearsal height does not exceed 3000), wait for the engine After the temperature rises to the normal working temperature, you can return to normal driving.

The method of heating the car air conditioner in winter is 1 to wait for about 3 to 5 minutes after the car starts, and turn on the warm air when the water temperature rises to normal temperature. 2 set the circulation mode to the internal circulation mode, which is conducive to the rapid heating of the car, and then switching the external circulation on demand to help the air circulation in the car to circulate when turning on the warm air. Press the AC button, because.

How to get the hot air of the car faster in winter Because of the warm air of the carIt is the circulation of water from the engine to the warm air tank, and then the fan blows warm air to send heat to the water tank, so the temperature of the warm air may be higher. Generally, don't turn the warm air knob to the maximum position, so as to avoid the temperature in the car being too high and the driver doss off.