HS code-driven route selection

Introduction to the car start-stop function icon With the continuous advancement of urbanization,HS code-driven route selection more and more vehicles have increased the problems of road congestion and air pollution.In order to solve this problem and improve the fuel utilization rate, the car start-stop function was born. Accompanied by is a small logo called "engine start-stop icon", which can be seen everywhere. This article will introduce this common logo from several aspects such as the principle and advantages of the car start-stop function. I. The principle and advantages of the car start-stop function. The car start-stop function means that when the vehicle needs to stop and wait while driving, or when there is a traffic jam, the engine will be automatically turned off and the engine will be started when the vehicle is ready to start. In this way, fuel consumption can be further reduced, emissions can be reduced, and environmental protection can be achieved. At the same time, for automatic gear vehicles, the start-stop function can also further reduce the loss of the engine under long-term idling when the vehicle is in idle, thus extending its service life. II. SendThe style of the motive start-stop icon explains that the application of the car start-stop function is becoming more and more popular. So how to identify whether the start-stop function is available? This requires the engine start-stop icon. This kind of logo is generally divided into three types: 1. Green car symbol with an arrow pattern with the letter "A" on it. This logo indicates that the start-stop function of the vehicle is activated. When the conditions for starting/stopping are met, the car symbol will change from green to gray. Two. The green car symbol does not have an arrow pattern with the letter "A" on it. This sign indicates that the start-stop function of the vehicle has been turned off. That is to say, the engine will not turn off automatically when the vehicle is idling at this time. 3. Red "Prohibit" symbol. This logo means that the start-stop function of the vehicle is not available. When you start the vehicle, the start-stop function icon will be on the dashboard.Flashing, and then turning into a red prohibition sign, indicating that you need to check whether the start-stop function of the vehicle is faulty. III. How to use the start-stop function? If you want to reduce fuel consumption and emissions through the start-stop function of the car, you need to pay attention to the following points: 1. Effective distance: In order to avoid the impact of the frequent start-stop of the engine, the start-stop function of the car is generally only used when driving at low speed or stationary. Therefore, when the speed of the vehicle is below 10km/h, or when the car stops and waits for the green light, the start-stop function will automatically start. If this speed is exceeded, the startup function will fail. Two. Acceleration reaction: It should be noted that when starting the engine, it takes about half a second for the car to restore power and oil pressure to start and stop the function. When you put down the brake and step on the accelerator, the car's start-stop function will start the engine, but it should be noted that the acceleration response of the engine may be slightly slower than usual at this time.3. Driving experience: Not everyone likes the start-stop function of cars, and of course, some people feel natural about it. No matter what type of person you are, you can decide whether to use the car start-stop function according to your own experience and perception. IV. Conclusion Although the icon of the car start-stop function is small, the meaning is very important. By interpreting this small logo, you can better understand the characteristics and operation essentials of the car's start-stop function. At the same time, you can also actively use the car start-stop function to contribute to the environment and vehicle maintenance.

Contact Us
Phone：020-83484694