HS code-based compliance cost reduction

List of the catalog of this article:

• 1,HS code-based compliance cost reduction Correct operation of manual transmission car start
• 2. correct starting method of manual transmission vehicle
• 3, Manual car How to start driving

correct operation of manual transmission car start

1. Confirm gear and handbrake. Make sure that the gear is idle and the handbrake is in a pull-up state. Hang gear. Step on the clutch pedal and brake pedal, start the engine, put the gear in 1st gear, and then release the handbrake. Lift the clutch.

2. The correct step for manual gear start is 1Completely step on the 2nd gear position and hang to the 1st gear 3 do the left turn signal 4 press the horn to remind 5 release the handbrake 6 lift the clutch with the left foot 7 the vehicle starts to start, the clutch of the left foot should be steady, and there can't be no pressure or lifting operation, so as to avoid turning off the engine 8 steady.

3. Start the engine correctly (tighten the parking brake, set the manual transmission in air) and observe whether the instrument is working normally. Turn on the left turn signal, adjust the rearview mirror and check whether there is any unsafe situation behind the car, and step on the clutch pedal. Hang the transmission joystick into the starting gear (1 gear or 2nd gear).

The correct starting method of the manual transmission vehicle

1. Confirm the gear position and handbrake. Make sure that the gear is idle and the handbrake is in a pull-up state. Hang gear. Step on the clutch pedal and brake pedal, start the engine, put the gear in 1st gear, and then release the handbrake.Lift the clutch.

2. The correct way to start the manual transmission is as follows: 1 The clutch is completely stepped on. After starting the car, the left foot completely steps on the clutch. This is for the half-clutch state to hang the 2nd gear to the first gear with the palm of the right hand, and hang the gear lever gear into the 1st gear as the starting gear. 3 The left turn of the left turn signal Control the direction lamp.

3. Start the engine correctly (tighten the parking brake, set the manual transmission in air) and observe whether the instrument is working normally. Turn on the left turn signal, adjust the rearview mirror and check whether there is any unsafe situation behind the car, and step on the clutch pedal. Hang the transmission joystick into the starting gear (1 gear or 2nd gear).

4. The correct way to start the manual transmission is as follows: step on the clutch pedal and hang the gearshift lever into the first gear. Press the horn and relax the handbrake.

5. The correct ways to start manually are: combining the clutch and the accelerator pedal, paying attention to the position and operation of the gearshift lever, actively slowing down to control the speed, lifting the clutch for a moderate time, and correct pedal control skills.

6. The correct starting method of the manual transmission car: be proficient in stepping on the clutch, practice more, and be stable.

How to start a manual car

1. Start the engine correctly (tighten the parking brake, set the manual transmission to idle) and observe whether the instrument is working normally. Turn on the left turn signal, adjust the rearview mirror and check whether there is any unsafe situation behind the car, and step on the clutch pedal. Hang the transmission joystick into the starting gear (1 gear or 2nd gear).

2. The best way is to step on the clutch and brake when starting. The handbrake can be used or not.When the clutch is lifted halfway, release the brake. At this time, the vehicle is in a semi-clutch state, and the car will not slip backwards. At the same time, add the accelerator, slowly release the clutch, and start successfully.

3. There are about two kinds: slow delivery clutch, wait until the semi-linkage, stop loosening the clutch, give a little oil, and then slowly release the clutch completely after the car starts moving. ( This is a relatively fuel-efficient starting method, but it is not suitable for ramp starting).

4. After starting the car, step on the clutch completely with your left foot to prepare for the semi-clutch state. Push with the palm of your right hand and hang the shift lever gear into the first gear as the starting gear. Press the turn signal control lever down with your left hand, and turn on the left turn signal to prompt the front and rear of the car.

5. The starting steps of a manual transmission car are as follows: adjust the seat before driving, and make sure that your feet can step on the clutch, brake and accelerator.

6. The first step of driving is to start the vehicle. When starting the manual transmission model, pay attention to step on the accelerator with your right foot, slowly lift the clutch with your left foot, stabilize the steering wheel with your left hand, and hold the front of the manual brake with your right hand; when you hear the accelerator sound from high-pitched to calm, quickly lower the manual brake.